TinyCircuits

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jpinzon

Pages: [1]
1
TinyDuino / Re: Send GPS data over BLE nordic NRF8001
« on: April 14, 2019, 02:32:36 PM »
I am trying this too with no luck. I used your code to check mine and with yours I was able to get the coordinates (GPS) on the serial printer in the MAC where the Tinyduino is connected. Via blue tooth I can connect to a Chromebook and I am able to send from the chromebook a message but it seems it does not work the other way. Any ideas?

2
TinyDuino / GPS CHECK
« on: June 07, 2016, 10:31:15 AM »
I have been trying to get the GPS working, but it is still not. I did have some luck a few weeks ago, but it seems now that the actual unit is no longer working. Is there a way to test it?

3
TinyDuino / Re: GPS Data and Failure of Tinyduino to Turn Back On
« on: April 02, 2016, 09:11:57 AM »
Dear Ben,
My apologies for my delayed response.
I have been experimenting with the GPS. For the most part, the GPS started working once I followed these steps:

Connect to computer> upload program > wait for it to get signal > use it!!! or turn off > turn on before use..

There were a couple of times where it did not start the card but have not figure out why.

My GPS is a Telit SE868 V2.

As for the power. Is there a charger for the tiniduino batteries that independent of the PC?


Thanks,
Jorge

4
TinyDuino / Re: GPS Data and Failure of Tinyduino to Turn Back On
« on: March 21, 2016, 09:01:08 PM »
Dear ALL,
I have been trying the GPS Cat Tracker for a week or so.

Yesterday, I installed the "TinyShield_GPS_V2" script. It uploaded to the board fine, the board starts getting reads from the GPS and writing on the SD card. However, if I remove the SD card to download the data and put it back afterward, nothing is written on the card. This also happens if I turn OFF and ON the board. In both cases, it seems that the board fails to initialize the SD card. Do you guys know if there is a way round these two situations?

If NOT, is there a way to "delay" the GPS readings to get one every two or five seconds instead of every second. I think this may give me more battery life. I am not planning to use this GPS as soon as I disconnected from the computer and would like to NOT have to bring the computer with me. I also need the small battery (the same sold by Tinycircuits).

Any help will be appreciated.
Thanks,
JP

Pages: [1]