1
TinyDuino Processors & TinyShields / Unable to get 3.3V on Proto Board
« on: February 06, 2014, 03:23:50 AM »
Hi,
I am new to tinyduino and have recently purchased TinyDuino Processor Board (with Battery Holder), TinyShield USB & ICP and Proto Board 1.
I have stacked up the Processor Board + USB Shield + Proto board and connected the micro USB from computer. My blink program compiled and executed correctly.
I extracted wires from the Proto Board 1 to connect another device (nRF24L01+) which operates on 3.3v supply. Although, I am unable to get the supply 3.3v on the proto board due to which I am unable to test nRF24L01+ any further. I then removed the micro USB and connected a CR1632 battery. Though still not able to get 3.3v to nRF24L01+.
Is there something I am missing?
Thanks a lot for your help.
Regards,
Manoj.
I am new to tinyduino and have recently purchased TinyDuino Processor Board (with Battery Holder), TinyShield USB & ICP and Proto Board 1.
I have stacked up the Processor Board + USB Shield + Proto board and connected the micro USB from computer. My blink program compiled and executed correctly.
I extracted wires from the Proto Board 1 to connect another device (nRF24L01+) which operates on 3.3v supply. Although, I am unable to get the supply 3.3v on the proto board due to which I am unable to test nRF24L01+ any further. I then removed the micro USB and connected a CR1632 battery. Though still not able to get 3.3v to nRF24L01+.
Is there something I am missing?
Thanks a lot for your help.
Regards,
Manoj.