Messages

1

TinyDuino Processors & TinyShields / BLE reflashing

« on: January 30, 2015, 10:35:22 PM »

So i understand that there are 6 pins (well spots for pins) on the back of the BLE v2 board.
But, what is best practice to access these pins with the CC Debugger.
Solder a header pins on it?
Seems a bit impractical to do this.
Is there a more elegant solution for reflashing?
I assume Ken and team have some kind of 'jig' that the board slides into, gets programmed and then gets removed?

Thanks!

2

TinyDuino Processors & TinyShields / Re: How to expose sensor data by defining readable characteristics in BGLib?

« on: September 02, 2014, 10:18:14 PM »

Hi
I am trying to do the same.
Any luck on your end?

I have been reviewing the BG Lib code and trying to see how to connect the TX from the processor to the RX of the BLE chip (Think that is right) using the accelerometer example as well.
Instead of sending it over serial send it to BLE.

If you have discovered anything please post. I will do same.