Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Pierre Flores

Pages: 1
Hi GrandPoohbah,

Thanks for the tip. I would like to avoid having to reset the board every time though, as 1) it is a bit tedious to do so, and 2) I'm afraid of damaging the bootloader button eventually. I understand that for Windows 7/8, TinyCircuits recommend to manually select a compatible driver (provided here : Is there a similar driver and procedure for Windows 10 ?


TinyDuino / TinyZero board not detected on Windows 10 Family Edition
« on: July 30, 2019, 05:22:42 AM »
Hello TinyCircuits,

I recently bought a TinyZero IOT kit and am following the setup tutorial to get started with it.

I followed the first part of the tutorial, that is the installation of the Arduino IDE with the appropriate board support packages.

When connecting the board to my laptop (with Windows 10 community edition) via USB, the laptop does not recognize the board. That is, I get a "USB device not recognized: Device descriptor error" on the device panel.

I tried several usb cables as well as different usb ports on my laptop, with the same results, so I doubt the problem comes from this.

I followed the tutorial on another laptop with Windows 10 Enterprise and then, the board was correctly detected and I could get the tutorial programs work, eg blink.

I worked a few times with the board connected to that other laptop (with Windows 10 Pro) without any issue. Now, however, I get the same "USB device not recognized: Device descriptor error" that on the other laptop (with Windows 10 Community). Again, I doubt I would be so unlucky that all my usb cables suddenly stopped working.

Would you have any clue to what happened there ?

Best regards,

Pages: 1
SMF spam blocked by CleanTalk