TinyCircuits

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - donde

Pages: [1]
1
TinyDuino / GPS Tracker
« on: November 07, 2018, 06:31:36 PM »
Can't get past this point. On Serial Monitor, I see:

Initializing Flash Memory...

Determining write/read start point...
Done.

Send 'y' to start read mode. Write mode will begin in 10 seconds...

Now initiating write mode.

Attempting to wake GPS module..

I GPS shield works, for just was using it for another tracker, The Cat Tracker. It of course uses an SD card shield. I substituted the SFI Flash shield. The 2 Includes I'm using are
#include "SoftwareSerial256.h"
#include <SPIMemory.h>
I tried 4800 for GPSBaud speed instead of 9600
The 4 boards are from top to bottom
GPS
USB
Flash
Tiny Duruino

Please help

2
General Discussion / WiFi Shield Learn
« on: November 06, 2018, 04:13:14 PM »
I already have 4 stacked boards for GPS logger. I would like to start another stack with your special cable that will connect to the WiFi board. It requires a Tinyduino and USB board. Can I use these existing boards from the 1st stack?

Pages: [1]