Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - littlejohn

Pages: [1]
General Discussion / Re: linux code upload and modemmanager
« on: October 27, 2018, 09:25:26 PM »
Hi, yeah the solution for that specific problem is in my post above...  ;D

What kind of problem are you having exactly?

General Discussion / linux code upload and modemmanager
« on: September 28, 2018, 05:18:03 PM »
Another issue I had, just FYI:

I had alot of trouble uploading code to tinyscreen+ on Linux. Half the time it would fail or tell me the port was busy. This is due to ModemManager scoping out any serial ports to see if they are GSM modems. You can fix this by putting a udev rule something like this in /etc/udev/rules.d/77-arduino.rules

# stop modemmanager from checking every serial port for a modem.. it locks up the port
# for a few seconds and interferes with uploading.
# arduino
ATTRS{idVendor}=="2a03", ENV{ID_MM_DEVICE_IGNORE}="1"
# tinyscreen / atmel
ATTRS{idVendor}=="03eb", ENV{ID_MM_DEVICE_IGNORE}="1"

...as described here:

General Discussion / Re: Stacking Connector
« on: September 28, 2018, 05:11:53 PM »

me too

General Discussion / had to try 3 different usb cables
« on: September 15, 2018, 04:31:56 PM »
just FYI, I was about to ask for help becuase my tinyscreen+ wasn't showing up at all when I plugged it in. I had tried two different USB micro cables on 2 different computers. Then I tried a 3rd cable, and now it is working fine. Touchy cables or touchy connector, I wonder.

Pages: [1]