TinyCircuits Forum

General Category => General Discussion => Topic started by: jgavlik on October 03, 2020, 12:37:37 PM

Title: Duel Motor TinyShield Schematic Issue
Post by: jgavlik on October 03, 2020, 12:37:37 PM

I believe that the schematic for the dual motor tinyshield is incorrect...looks like the sensor board schematic, instead.  Go here and click on schematic to confirm.  Thanks....john

https://tinycircuits.com/collections/motors-1/products/dual-motor-tinyshield

Title: Re: Duel Motor TinyShield Schematic Issue
Post by: jgavlik on October 04, 2020, 11:58:58 AM

Looks like the entire "download" section is mistaken, as well.

And, yes, it's Dual (not Duel) Motor TinyShield...jg

Title: Re: Duel Motor TinyShield Schematic Issue
Post by: lennevia on October 05, 2020, 12:11:49 PM

John,

It looks like some recent updates went wrong on this page. I will fix them up today.

Thanks for the catch and letting us know!

Title: Re: Duel Motor TinyShield Schematic Issue
Post by: jgavlik on October 05, 2020, 02:21:27 PM

Rena,

Thanks for the fix!

Question....do mating connectors with wires exist so that one can connect (plug in) a DC motor to the board (and solder the wire ends to the motor_?

John

Title: Re: Duel Motor TinyShield Schematic Issue
Post by: lennevia on October 06, 2020, 12:42:46 PM

John,

We do have 2-pin JST cables that you could solder onto a motor to use with the Dual Motor TinyShield: https://tinycircuits.com/collections/cables-connectors/products/jst-sh-2-pin-connector

We also have 3-pin JST cables for servos if you were interested in those as well: https://tinycircuits.com/collections/cables-connectors/products/3-pin-jst-sh-pigtail-100mm

Hope that helps!

Title: Re: Duel Motor TinyShield Schematic Issue
Post by: jgavlik on October 06, 2020, 01:04:59 PM

Rena,

This is what I was looking for...thanks....john