TinyCircuits Forum
General Category => New Product Ideas => Topic started by: eecho789 on September 04, 2013, 08:19:51 PM
-
Ive been using a custom etched proto board with soldered pins so I can plug my Tiny Lilly in and have easier access to everything. I currently have a 74xx595 and uln2803 smd added to the board so I can expand the outputs and capability of the board. It'd be nice to have a little board with these built in to add to my tiny lilly projects... Oh and maybe offer a few blank cut round pre drilled PCB's! Etching them is no problem, but cutting a round blank is tedious! I could make my own custom boards if those were available!
-
We have a die that trims the round lilys so we Might be able to cut out blank round boards. Drilling all those holes would take some time though.