TinyCircuits Forum
General Category => New Product Ideas => Topic started by: ndelson on August 30, 2013, 10:15:39 AM
-
Could you make a Proto Board with a double sided connector?
I have already done 2 projects where I would have liked a double sided connector on a Proto Board specifically so I can attach and LED Shield as the top shield. the LED Shields are so neat, but once you connect a Proto Board you have to hide your LEDs inside the pack where they are much less visible.
Thanks
Nate
-
I think I read that these are already in the works. I'm looking forward to them.
-
That would be a fantastic addition. This would allow multiple prototype boards to be used. Put in my vote too!
-
Me too! Also posted in the other thread.
-
I agree!!
-
Noted
-
Bumping it up. I`m stuck with my project because existing boards have conflicts, so I have to do some manual wiring with protoboard, but can`t have the led or digit display on top of the sandwich! That's really inconsistent design...
Please fix that.
-
You should check out the Proto Terminal Block TinyShield which has a double sided connector, and can be used without the terminal blocks to basically do exactly this, and it's very easy to get access to the signals.
https://tiny-circuits.com/tiny-shield-proto-terminal-blocks.html
Ken
-
You should check out the Proto Terminal Block TinyShield which has a double sided connector, and can be used without the terminal blocks to basically do exactly this, and it's very easy to get access to the signals.
https://tiny-circuits.com/tiny-shield-proto-terminal-blocks.html
Ken
Hi,
It might be a workatound for now.. The downside is its size obviously. But thanks!