TinyCircuits Forum

General Category => New Product Ideas => Topic started by: braza on August 20, 2013, 04:25:43 AM

Title: hull/body
Post by: braza on August 20, 2013, 04:25:43 AM

Hi all,

I know that it`s not an electronic really, but I think it`s a reasonable idea to produce some hull/body for the tinyduino sandwich. I need one and the best option for me now is a 3D print, but there are few thing that can`t be easily achieved with it. Here is my list of needs, let`s see if anybody think it makes sense for anyone else:

• Be solid and tightly fit the sandwich, probably have its own screws and buffers for the corner holes in boards, shockproof
• Have one side transparent so that multiled or eInk or any other displa could be read
• Probably have the same connector as boards have and have a wire or slot connector outside of the hull
• Be waterproof in the closed state
• Some

Title: Re: hull/body
Post by: flintols on August 20, 2013, 10:13:04 AM

It looks like that would depend on the shield. Could easily make 3D print versions (stl files) based on board design.