TinyCircuits Forum

TinyCircuits Products => TinyDuino Processors & TinyShields => Topic started by: thompsc2 on July 21, 2015, 01:09:28 PM

Title: Accelerometer interrupt question
Post by: thompsc2 on July 21, 2015, 01:09:28 PM
Are INT1 and INT2 on the accelerometer shield connected to pin 2 and pin 3 respectively on the TinyDuino? Thanks.
Title: Re: Accelerometer interrupt question
Post by: Grimstone on July 22, 2015, 04:42:14 PM
Pins A4 and A5 are used by this shield. There are direct wiring points for INT1 & INT2 as well.